Hi Randolph,
You have a nice web site :) http://www.heat2power.net/
http://www.heat2power.net/en__benchmark.php like this link best
Do you think the Heat2power could generate power to operate another
rotor from the heat of two rotors?
Marc Joseph
Dear Marc,
Thank you for the compliments regarding my website.
Yes indeed it would be possible to use a third rotor for regenerating
heat from the first two rotors.
But I would suggest you continue the path with turbo-compounding first
because what I understand is that you have high gas velocity available
at the exhaust port of the rotary.
Use that first and you will also see that the temperature will drop a
bit on the way down the expansion.
But still there will be lots of heat available . Only then work with
waste heat regeneration.
This will in my opinion get the most mechanical power out of the fuel.
Make that engine run on propane so you will have low CO2 emissions per
kWh as well.
What about making a serious project out of this? For an application on a
truck for example?
Focus on a continuous power output that corresponds on steady state
motorway driving of a class 8 truck.
I am sure you could get some serious grants for this on the basis of
solid calculations.
Amory Lovins from RMI or Charles Roberts from SWRI may be interested and
could be contacted for helping us work this out perhaps.
Does anyone have suggestions for this? You seem quite advanced with the
rotary itself. And on the way to turbo-compound it.
Best regards
Randolph
Randolph Toom
Managing Director
heat2power SARL
www.heat2power.net
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.