Subject: Cowl flaps and exit air
From: Rotary Engine
Date: 12/22/2008, 8:48 AM
To: AAA Put this in the To box

Paul,

Let me add my two cents to the cooling exit discussion.

While there may be a theoretically optimal inlet/exit ratio for drag,
wouldn't it be more important not to put more cooling air through the
cowling than is needed? I assume that liquid-cooled engine have
thermostats, and so the engine getting too cold is not a problem. But
the inlet has to be sized for the most adverse hot-day climb condition,
and so it will be able to admit far more air than is needed for, say,
economy cruise at altitude on a cool day. If you determine the outlet
area by some rule of thumb, say 80% of the inlet area, then you will be
on the thermostat and will be pumping air through the cowling for nothing.

There is a sort of mania these days for small inlets, but I think you
would agree that there is no harm in a large inlet, provided that it has
a well-formed lip. Pressure recovery occurs before the inlet, and
un-needed air flows smoothly around it. That's why radial-engined planes
still go fast. Opening and closing the outlet moves the stagnation line
on the inlet lip, and in the case of maximum spillage it actually yields
some duct thrust, just like on your inflatable shrouds.

My plane has about 60 sq. in. of inlet area (200-hp engine), and the
outlet area can be adjusted from 98 to 18 square inches. I normally
cruise with the cowl flaps fully closed.

Peter Garrison

http://www.melmoth2.com/texts/NACA%20inlet%20sizing.htm

I agree Peter. In fact I suggest a thermostat NOT be installed and the
engine temperature controlled with cowl flap alone. I too cruise the
C182 with the cowl flaps fully closed. Of course there is a lot of leakage
around the crude C182 cowl :)


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.