> Interesting page, Where can I get more information on using rotary
> engines in aircraft and cars. I am building a lotus 7 replica that I
> want to have 500 reliable hp out of. Also I am building an aircraft
> that I want to create as a ducted fan aircraft. This takes lots of HP.
>
> DB
>
> 400 HP normally aspirated is no problem for a 3 rotor at 10,000 RPM.
>
> 400 HP turbo charged is no problem for a 2 rotor but everything
> must be right as it is more sensitive to mixture and boost.
>
> Ducted fans are horribly inefficient in the 100 to 200 MPH speed range.
> My guess on top speed with 400 HP would be well under 200 MPH.
> Of course there would be lots of fuel burn on the order of 200 pounds
> per hour or 32 gallons an hour. Those that have tried have gone back to
> props.
>
> Paul Lamar
Thanks for the data. Yes I agree with the problems of the duct fan.
But there has got to be a way to make that work. The jets do it and
with enough power a piston engine could too. (my thoughts) perhaps a
better thing to do would ba a shrouded fan similar to the RFB Fantrainer.
David
Jet airliners are going further and further from requiring ducts on
their turbines. The latest Pratt and Whitney engines run a gear
reduction on the bypass stage (making it turn slower) and are seeing
double-digit improvements in fuel economy. A turboprop is even better
for efficiency. The only benefit provided by the duct is increasing
the efficiency of a fan for which you don't have enough room for
adequate diameter and/or when you don't want to gear down the fan
section to control fan tip speed (trans/super-sonic losses).
Regards,
Matt-
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.