Here is a company that makes something similar in a range of sizes.
This is the one used on the Rotamax 2 rotor engine. The unit Rotamax
chose was 60 durometer and the resonant frequency was about 2000 RPM.
We ordered a 50 durometer version and that lowered the resonant RPM
to about 1800. Next step would be to drill some holes in it to lower
the idle RPM lower still. Or one could try the next smaller size.
Paul Lamar
Paul and George,
Sorry for the late reply; today is my first day back in the office after
the Christmas closure.
Unfortunately I don't have any records of what exactly was used on the
MWE/Diamond engines. I do recall though that we were using Centaflex
couplings on the gearbox of MWE-twins as depicted, size unknown though.
We used exactly the same couplings to couple the 300cc single rotor
engines without a gearbox directly to the pass-off dyno as well. They
worked ok for quite some time as long as we kept the engines above
2.800rpm.
I do remember as well, that, in the past, when we were using larger
diameter couplings, we had more problems!
Interesting enough those very couplings exploded within seconds (!) when
we had the first R7 (400cc single rotor engine, now officially called
IAE75R) on the same dyno. We tried to run the engine at elevated
tick-over, 2.500 - 3.000rpm several times with and without load.
Eventually we had to disconnect the engine from the power take off and
ran it without any coupling (hence without applying any load!) for a
quick first demonstration run. The engine was then shelved until I left
Diamond, so I don't have access to any more recent information.
Maybe it's worth getting in touch with Austro Engine and order a new
Centaflex coupling for a GIAE110R engine! I can clearly visualize loads
of them in the ex-Diamond Engine stores. That would get you at least a
sample and a guideline of what size to go for.
Regards and good luck!
Martin.
The Austro part will only work for the small displacement Austror engines.
A one rotor Mazda is a monster by comparison. More like the big Austro.
Here is the Centaflex catalog.
Also a couple of picture of the torque isolator found in all moto cross
off road dirt bikes. Probably near ideal for a large one rotor engine.
Paul Lamar
Paul,
This is what I'm planning on using for the single engine. The drive plate
will look similar to the Marcotte drive plate.
The outer diameter of the rubber inserts is 140mm, additionally they have a
5mm flange. This might not bolt onto a flex plate and I may make a special
flywheel, perhaps heavier than the flex plate but much lighter than the
manual flywheel.
The rubber inserts are 34mm with an 8mm bolt a 2mm walled spacer. The outer
dia of the flanged insert would then be 44mm.
I will make up 3 sets of damper rubbers one soft one hard and one middle
range.
George (down under)
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.