This was long over due.
Check it out.
http://www.rotaryeng.net/mm-instruct.html

Paul Lamar

Paul,
Very nice and clear writeup on the Motor Mount Design. By the way, I fell on
the ice and broke a rib, so am out of commission for a while. It will heal,
but it P**** me off not getting to test my KIS.

Bill Schertz
KIS Cruiser #4045
N343BS


Thanks.
Sorry to hear that Bill. That is why us old guys move to warmer climes. :)
Robin fell and dislocated her shoulder. Took her six months to recover
and it still hurts from time to time when I ask her to cook :)

Paul Lamar

You got that right, Paul. I was told a long time ago that is easier to walk
in a foot of heat than in a foot of snow. I tryed  it and it is true.
By the way, great write up. It should make a lot of home builders understand
why motor mounts are built the way they are. Adjusting a design to
individual requirements without making a bad motor mount should be easy with
your write up as a template.

Just finished the rotor housing mods for the flyable engine
configuration(Picture).

Richard Sohn
N2071U

Looks good Richard. Did you weld that p-port or bond it in?

Paul Lamar