Subject: Engine mount photos (RV-4)
From: Rotary Engine
Date: 1/14/2009, 4:58 AM
To: AAA Put this in the To box


Paul,  here are photos of the RV-4 engine mount which I finally got
welded up after some delay.  I will post about 25 photos on my web site
later this week.  If you would like to have them I will send to you as
well.  The main difference is the improvement in weld appearance which I
am extremely pleased with.  Total weight with the Barry bushings, oil
pan and  pick up tube is 26 lbs.  This mount does gain some weight
 because of the landing gear sockets and associated structure.  I like
the first photo which shows how the rear beam is used to tie everything
together while at the same time keeping the tubing well clear of the
engine.     Jerry


That is a beauty Jerry. Yes send them to me.

Paul Lamar



Great job Jerry.  Regarding comparative weights, a stock RV-4 Lycoming mount
is exactly 15 lbs including gear leg sockets and dynofocal mount seats but
no rubber mounts/bushings, but it appears an accurate weight comparison
would provide for subtracting from your rotary engine mount the total weight
of the oil pan and pickup, and Barry bushings.   Do you know the total
weight of those components?  Paul, are the mount dimensions for the cowling
shape you showed in your note yesterday?


Steve Beckham.

Jerry is a bit conservative on the oil pan wall thickness
at .125. Easier to weld than .090" thick. My guess for the oil
pan is 3 to 4 pounds. If it is .1875 thick it would be 4 to 5 pounds.
One difference is the 4130 .0625" thick Schertz beam as it is long enough
to accommodate a muffler or turbo charger mounted adjacent to the engine.
It also keeps the rubber bushings away from the exhaust heat as far as possible.
It weighs about .21 pounds per inch less the lightening holes. If it were 20" long
it alone would weigh about 4 pounds less the mounting bolt tubes. My guess is
5 pounds. I would not go down on the thickness to .049" to save weight.

Here are the RV4 mount dimensions.

Any idea what a Lycoming O-360 oil pan weighs?
Total weight of the O-360 is about 290 pounds.
The rotary with 40 pound PSRU less rads and coolant is
about 260 pounds to 270.

If you used Racing Beat aluminum end housings you would have
an aft CG problem :)

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.