Subject: Tangential muffler and fishtail muffler
From: Rotary Engine
Date: 1/15/2009, 3:54 PM
To: AAA Put this in the To box


Hello Paul,

I've moved on to an exhaust system, now. I live on a lake surrounded by
neighbors so my operating area is somewhat noise sensitive. I like the
combination of the tangential muffler and a fishtail muffler that you show
on your site. They seem very simple to construct. I've attached a drawing to
illustrate how they could be installed in my airplane. I could only get 8"
on the fishtail rather than the 16" you show. I might be able to get a few
more inches out of it.

Q1: How does this look to you? Do I need all 16", or do I adjust the exit
area?

Q2: You show the exit to be 9.5" x 3/8". The area of a 3" pipe is closer to
9.5" x 3/4" or about twice what you are calling out. What's happening there
with the smaller opening?

Thanks,

Sandy McNabb
Renesis in a Glass Goose


Looks pretty good.
Q2 it speeds up the exhaust air and provides a bit of thrust.
Sort of a poor man's turbo compounding. Worth about 400 HP on the P51 at 400
MPH. Not much HP at 100 MPH however.
In your case probably not a good idea for a slow airplane.

 Great minds work in similar fashion. I was just thinking about that for
the side mounted rad in the RV8 mount I just completed.
It too will fit in the cowl under the engine. The exhaust can then be made
to extract air through the cooling system.

The thing about fish tails is they have to be beefed up because the flat
panels are resonated by the exhaust pulses.
Figure on .062 inch thick 321 SS with stiffening ribs welded on here and
there.

All and all a positive thing.



Paul Lamar

--==========================

Thanks Paul,

I'll beef it up.

I was interested in the fishtail due to it's streamline shape in the
slipstream rather than a round 3" pipe sticking up.

Q1: Should I change the shape or size in any way since I can't get the full
16"? I'm just using it for it's shape.

Q2: I understand the area of the exhaust exit affects the sound and back
pressure...and they are inversely proportional....smaller area yields less
sound, but more back pressure. What am I looking for with this engine?

Thanks,

Sandy

Q1 Not mandatory but the effectiveness might be compromised some what.
Not enough to not do it.

Q2 low back pressure. Prop noise will be a major factor.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.