Not entirely done as I will be updating it from time to time
depending on your questions.
http://www.rotaryeng.net/simple-cheap-555.html
Paul Lamar
Paul,
Thank You!!!!!
Joe
Your welcome Joe.
Paul Lamar
Paul,
nice write up. The only thing we are doing signifigantly differnet is to
sum
in 2 thermocouples for engine temperature and for inlet air temp in the
control portion. Then engine will want to be a little rich for cold start
and idle stability until temps are up a little.
Just makes it more user friendly.
Larry
Thanks Larry.
Yes it would be. As it is now it is about as user friendly as my C182 :)
Full rich for takeoff, climb out and landing. The carb has no temperature
compensation :) I am used to it.
Paul Lamar
Paul,
the 182 is also running considerably richer than a liquid cooled engine at
full rich as they use the fuel to cool the cylinder heads. We only need to
be rich when the engine temp is low. By the time you taxi to the active and
do a run up, there should be enough temp to not need a rich mixture. Full
power rich on the rotary is considerably leaner than the air cooled engines,
but our cold start mixture is about the same. I just prefer to automate a
known and predictable condition.
During taxi, I am busy doing the CIGARS checklist and prefer the engine
takes care of itself.
Spark plug life will be much better if we correct the air fuel based on
temperature. Rich mixtures on a rotary is hard on the plugs.
Larry
Well all that may be true but SOP in most air cooled light aircraft I am familiar
with and have flown (Cessna's, Pipers and Mooney's) is to take off and climb out at
full rich. In the case of aircraft turbo engines the BSFC is a high 0.65.
That has got to be around 10:1 air fuel mixture or worse. Max power is 12:1
and best cruise is 14:1 or higher. The exception of course is high altitude
airports where you set the mixture to max static RPM and power.
I am not saying temperature comp. is a bad idea. It just makes it a lot more
costly, complicated, harder to build, trouble shoot and repair. I want to keep
this as simple as possible to keep it as cheap, reliable and easy to build for
the home builder.
There is a subsidiary advantage to pilot involved simple carburetors and
fuel injection. It trains the pilot as to what is really going on with the engine.
If things are too automated the pilot has less awareness of how the mechanism
works.
I once had a float sink in a C172 carburetor. I was able to identify the problem and keep
the engine running by judicious leaning until I was able to land. Without leaning
the engine would flood and quit. My knowledge of carburetors was invaluable at
that point.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.