> >>> Not entirely done as I will be updating it from time to time
> >>> depending on your questions.
> >>>
http://www.rotaryeng.net/simple-cheap-555.html
> >>>
> >>>
> >>> Paul Lamar
> >>
Paul,
- Thanks very much for this work and for publishing it in such a
readable form.
- When you're satisfied with the final design, do you think it would
be useful to make available a small kit of parts? If you don't want to
do it yourself, perhaps you could tag someone else to take on the grunt
work (someone who knows how to make/procure the printed circuits?) It
could probably include the PCBs, the TC 555, and the electronic
components, heat sink, connectors, maybe even a small chassis box, etc.
- The only substantive observations/comment I've got on the design
relate to reliability/redundancy. We should look at what could fail and
how we could keep the motor running in various failure modes. I'd see
possible failing components as: MAF sensor, crank angle sensor, fuel
injectors, controller. Two approaches seem practical:
A) It would seem possible to have a physically separate controller
that used no input from the sensors and had maybe four manually
selectable "limp home" power settings, a leaning potentiometer, and an
"A/B/ALL" selector that enables selection of various sets of injectors
in each rotor (e.g. 4 injectors (ALL) or the "left" or "right" single
injector in each rotor.) If we install injectors with enough capacity,
the engine should run fine at lower power settings on one injector per
rotor. This backup FI controller would allow continued engine power
even with simultaneous failure of all sensors, the main FI controller,
and up to two injectors.
B) Duplicate your present design in a backup controller: No "limp
home" modes, but add a second MAF sensor, RPM sensor (independent of the
CAS), and A/B/ALL selector for the injectors as described above. If the
motor gets quiet, the pilot just selects "system 2" and everything
operates just as it used to.
Regardless of the type of backup FI controller we end up going with (if
at all) I'd be interested in your opinions regarding addition of
A/B/BOTH injector selection to your present design. Selecting "A" would
double the pulse width going to "A" and close off the "B" injector in
each rotor.
I'm not an engineer (I'm sure it shows) but those are my ideas.
Again-thanks very much for your work.
Mark Waldron
I think Bob White might be interested in selling a kit of parts.
I have some PC board art work that I can send him.
Both A & B would work fine.
Another back up system is do what Klaus did. Put two small gasoline
feed tubes, made from steel brake line, into the intake runners and
feed them with a needle valve. This requires a gravity feed auxiliary
tank or a low pressure fuel pump with a pressure regulator. You don't
need to be able to take off with it. It just keeps the engine running
until you can land.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.