Dear Paul
I am a newly signed up member, I have watched the website for a
while and recently joined.
I have a self built quickie with a 0235, but also have two 13b's.
And plan to convert one of them to my plane, I looked at Tracy
Cook's injection but it he says his system will not hand prop. As I
am limited to 100bhp (being in England, something to do with our air
being different to the rest of the world?).
Anyway because of that I planed to use the rotary direct drive, so
the 555 injection on your web site. Looked interesting, is it
possible to obtain more details and the pcb's.
Has anyone built one using Lightspeed MAP output to factor in load
for a constant speed prop?
If I am out of sync.
Clive
I will be working on the injection system some more when I get back
to the states next week. I don't recommend a rotary for direct
drive. You need the prop to turn at less than 3000 RPM to be
efficeint. At that RPM you would be lucky to see 50 or 60 HP from
the 13B rotary while the weight would be well over 200 pounds. For
direct drive there is no replacement for displacement. You might
look into a pneumatic starter for the rotary. That should be less
weight than a alt, battery and starter. Plumb high pressure air into
the combustion chamber after to dead center. The Russians do it all
the time.
Paul Lamar Still down under
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.
Hi All -
The PFA will have a definitive answer on the 180 HP ( IIRC ) limit &
how this is measured & verfied in this Island of econo - boxes :^)
Fly & Build Good - Bryan In England
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.