Don Dunbar, Dave Mccandless and I took a close look at this Revmaster carb for
use with rotary, One would need two to get over 200 HP.
This looks like a good low cost and simple solution for the fuel system.
It appears to be  a Mikuni flat slide carb of some kind with the float
bowl removed. However I cannot find the exact Mikuni model or on what vehicle
it was used. I suspect the float bowl is removed to allow the mixture
to be adjusted using a low pressure gravity fuel feed. Rather brilliant
idea on Joe Horvath's parts. Joe is charging $330 each so I'll bet the
original version with float bowl is a lot cheaper.

Any body recognize this carb body?


Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.