Don Dunbar, Dave Mccandless and I took a close look at this Revmaster carb
for
use with rotary, One would need two to get over 200 HP.
This looks like a good low cost and simple solution for the fuel system.
It appears to be  a Mikuni flat slide carb of some kind with the float
bowl removed. However I cannot find the exact Mikuni model or on what
vehicle
it was used. I suspect the float bowl is removed to allow the mixture
to be adjusted using a low pressure gravity fuel feed. Rather brilliant
idea on Joe Horvath's parts. Joe is charging $330 each so I'll bet the
original version with float bowl is a lot cheaper.

Any body recognize this carb body?


Paul Lamar


Try this Edelbrock motorcycle carburetors web page.
http://www.edelbrock.com/motorcycle/carbs/intro.shtml

Clive Clapham

Thanks
That Looks like it.

Paul Lamar