Subject: Don Dunbar RX8 Powered Mustang II
From: Rotary Engine
Date: 2/23/2009, 8:57 PM
To: undisclosed-recipients:;


 Don is also building a Mustang II as well as a Berkut.
 He has designed and a friend machines his own PSRU's.
 I don't know where he gets all the time.

 Paul Lamar


Paul,

Tried to read the figure provided.  It does not take magnification
well.  Any chance you might have a more detailed schematic, or even
better, a set of plans?  Do you have more information on the rubber
flex connector?

Thanks,
Gordon
--

Try these three DWGs. Let me know if you need them in some other CAD format.

The coupling is a Lord. Here is a pdf of their catalog. The one Don has is
a bit stiff so you probably need a softer one to get the idle RPM
below 2500 engine RPM.

Paul Lamar


Thanks Paul!

I am in your debt.

Gordon

Thanks to Don.

BTW can you send me a larger screen capture jpg of the DWG? Rhino won't import
those DWGs

I think he is doing another design with a hollow
shaft for a constant speed prop. There is real need for that.

Paul Lamar

Never mind about sending the jpg's Gordon.
I ran Redhat Fedora 8 Add-Remove software and found
free QCad. I downloaded QCad and installed it in a few minutes.
I then converted Don's dxf file to this jpg directly.
Wonderful!!!!! I have been looking
for something like this for the past 30 years!!!!!!!!!! :)

I love Linux :)

Paul Lamar back in LA.
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.