Subject: Don Dunbar Harley alternator
From: Rotary Engine
Date: 2/24/2009, 3:16 PM
To: AAA Put this in the To box


These permanent magnet alternators make a lot of
sense. Super simple so they are intrinsically more reliable.
No field windings to deal with. No belt drives.
As I recall this one is about 40 amps.
Don intends to mount it on the nose of the
e-shaft. Should be interesting due to the higher
RPM of the rotary compared to the Harley engine.
If it lives it may put out a bit more current.
This is very similar to the Revmaster alternator.

One of the unique features of the Revmaster
alternator is it has two higher voltage coils built in
that apparently generate 300 or 400 volts AC for an ignition
system. Super simple for a two rotor as the coils
can do the timing automatically. Thus the coils directly excite
the primary of the stock Mazda coils raising the secondary
voltage to 20,000 volts or so to fire the plugs.
Extremely simple and should be absolutely reliably.
No battery voltage required. Better than a mag or anything
else for that matter.

I think this is well worth experimenting with.
The ultimate aircraft rotary ignition system.

Paul Lamar

Paul,
I really like the flywheel alternator with only one worry. Back in the
early seventies the Kawasaki Z1 used a permanent magnet alternator. The
alternator was super reliable but the voltage regulator went through
several redesigns. Being unable to control the output by shutting off
the field windings is a bit harder. Modern electronics can probably
handle it reliably. I don't know, since electronics isn't my field.
Bill Jepson

One can use what is called a switching regulator.
It basically controls the voltage with a 555. Same as we are
using in the 555 EFI. The pulse width is changed to keep a charged
capacitor
at a constant 14 volts. These are about 85 to 95% efficient.
The technology is highly developed and cheap down to one or two chips.

Paul Lamar

Any trouble caused by handling the full alternator output?
Just checking as I've seen some burned batteries and they aren't pretty.
Can you tell me how the regulation is done? The only full power system I
can recall off the top of my head are the old ziener diode systems on
ancient
BSAs and Triumphs
Bill Jepson

The current is turned on and off thousands of times a second.
If the voltage is too high the system shuts off. Every computer
in the world has a switching power supply that takes up
to 220 volts AC and converts it to 5 volts DC or less for the chips.
You may own several of these things and not know it.
They are about a ubiquitous as sliced bread.
(Wow! I spelled that correctly with out using the spelling checker :)

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.