Subject: Don Dunbar Harley alternator
From: Rotary Engine
Date: 2/24/2009, 7:05 PM
To: AAA Put this in the To box


These permanent magnet alternators make a lot of sense. Super simple so
they are intrinsically more reliable. No field windings to deal with. No
belt drives. As I recall this one is about 40 amps. Don intends to mount
it on the nose of the e-shaft. Should be interesting due to the higher RPM
of the rotary compared to the Harley engine. If it lives it may put out a
bit more current. This is very similar to the Revmaster alternator.
One of the unique features of the Revmaster alternator is it has two
higher voltage coils built in that apparently generate 300 or 400 volts
for an ignition system. Super simple for a two rotor as the coils can do
the timing automatically. Thus the coils directly excite the primary of
the stock Mazda coils raising the secondary voltage to 20,000 volts or so
to fire the plugs. Extremely simple=2
0and should be absolutely reliably. No battery voltage required. Better
than a mag or anything else for that matter.
I think this is well worth experimenting with. The ultimate aircraft
rotary ignition system.
Paul Lamar

Paul, I really like the flywheel alternator with only one worry. Back in
the early seventies the Kawasaki Z1 used a permanent magnet alternator.
The alternator was super reliable but the voltage regulator went through
several redesigns. Being unable to control the output by shutting off the
field windings is a bit harder. Modern electronics can probably handle it
reliably. I don't know, since electronics isn't my field. Bill Jepson
One can use what is called a switching regulator. It basically controls
the voltage with a 555. Same as we are using in the 555 EFI. The pulse
width is changed to keep a charged
capacitor at a constant 14 volts. These are about 85 to 95% efficient. The
technology is highly developed and cheap down to one or two chips.
Paul Lamar
These Alternator/Regulators don't have a good reliability record on
Harley's. If the Shunt Regulator does not fail first, the Stator will
develop shorted turns.
JCP --  Probably an over heating problem.
All electronic parts must be kept cool.
Paul Lamar

I am by no means an expert, but I have two Harleys and neither one has
ever given me any trouble with the alternator going bad. One bike is
air cooled and the other is a liquid cooled V-Rod. Nothing has ever
gone bad on them.
John Bell

The quality of the magnet wire is a factor.
There is a very thin coating that acts as insulation. If there
are gaps in the insulation turns can short out. The voltage
between turns is very low however. On the order of less than .5 volts.

Paul Lamar

John,
I don't know how hard or regularly you ride your bike, my experience is that
the Harley alternators have a track record of failing - in the worst
possible places. I think the Custom Chrome was the better alternative.
George (down under)



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.