These permanent magnet alternators make a lot of
sense. Super simple so they are intrinsically more reliable.
No field windings to deal with. No belt drives.
As I recall this one is about 40 amps.
Don intends to mount it on the nose of the
e-shaft. Should be
interesting due to the higher
RPM of the rotary compared to the Harley engine.
If it lives it may put out a bit more current.
This is very similar to the Revmaster alternator.
One of the unique features of the Revmaster
alternator is it has two higher voltage coils built in
that apparently generate 300 or 400 volts for an ignition
system. Super simple for a two rotor as the coils
can do the timing automatically. Thus the coils directly excite
the primary of the stock Mazda coils raising the secondary
voltage to 20,000 volts or so to fire the plugs.
Extremely simple=2
0and should be absolutely reliably.
No battery voltage required. Better than a mag or anything
else for that matter.
I think this is well worth experimenting with.
The ultimate aircraft rotary ignition system.
Paul Lamar
Paul,
I really like the flywheel alternator with only one worry. Back in the
early seventies the
Kawasaki Z1 used a permanent magnet alternator. The
alternator was super reliable but the voltage regulator went through
several redesigns. Being unable to control the output by shutting off
the field windings is a bit harder. Modern electronics can probably
handle it reliably. I don't know, since electronics isn't my field.
Bill Jepson
One can use what is called a switching regulator.
It basically controls the voltage with a 555. Same as we are
using in the 555 EFI. The pulse width is changed to keep a charged
capacitor
at a constant 14 volts. These are about 85 to 95% efficient.
The technology is highly developed and cheap down to one or two chips.
Paul Lamar
These Alternator/Regulators don't have a good reliability record on
Harley's.
If the Shunt Regulator does not fail first, the Stator will develop
shorted turns.
JCP
--
Probably an over heating problem.
All electronic parts
must be kept cool.
Paul Lamar
I am by no means an expert, but I have two Harleys and neither one has
ever given me any trouble with the alternator going bad. One bike is
air cooled and the other is a liquid cooled V-Rod. Nothing has ever
gone bad on them.
John Bell
The quality of the magnet wire is a factor.
There is a very thin coating that acts as insulation. If there
are gaps in the insulation turns can short out. The voltage
between turns is very low however. On the order of less than .5 volts.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.