Subject: Revmaster alternator and ignition for Mazda rotary
From: Rotary Engine
Date: 2/26/2009, 6:01 PM
To: AAA Put this in the To box


I did not mean to send that out to everybody but the
cat is out of the bag so here is what I am going to do.
Those two Revmaster ignition coils put out 300 volts AC. They just
happened to be timed correctly for a two rotor
engine since they were designed for a four cylinder engine.
Two rotor engines fire twice per rev 180 degrees out
of phase.

I intend feeding that 300 volts AC into the primary winding
of 2nd gen Mazda ignition coils minus the igniter parts.
We all have plenty of those lying around.

You unbolt them from the igniter frames and use just the three coils.
One for the upper plugs and one each for the two lower
plugs. You no longer need the igniter parts with the ballast
resisters that are prone to failure in aircraft use.

The Mazda coils will act as a pulse transformer with
out heating up. Just like a CD ignition coil would work.
Hopefully we will get 20,000 volts or more out of the secondary
to fire the Mazda plugs.

If it works this is just about the simplest and most reliable ignition
system you will find anywhere. No conventional alternator and no battery
required to keep your engine running assuming you are using gravity
feed carburetors. It will work a lot like magnitoes only better.
You get a free alternator in the bargain.

You adjust the ignition timing by rotating the Revmaster coil assemble.

Paul Lamar

Paul,
I think you have a good idea with one possible problem.
The 1972-79 Kawasaki 2 cycles used a similar system to run what they
called a "magneto CDI." What you are planning won't be CDI of course,
more like a standard magneto. The problem I forsee is start and idle.
When the magnets are moving slow it can be hard to get high enough
voltage to fire the coils. Kawasaki's solution was to run a low-speed coil
with more windings to produce enough power at idle or starting. The
system was very reliable. In fact the only thing that ever failed on them
was the low-speed coil! One other thing that the magnet system will provide
is at least some timing advance. As the speed picks up the flux is
greater and
the advancing sine wave is a greater aplitude and the crank/e-shaft angle
at which you have enough power to fire the plugs advances. this is usually
a benefit as you get better performance and economy. You do need to
double check your timing at full power to be sure you don't get too much
advance. If it will start/idle you should be home free.
Bill Jepson

Well I think I have to build a stand alone system with just two magnets
and try it and see what happens. I can use my lathe to change the speed.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.