Subject: Revmaster alternator and ignition for Mazda rotary
From: Rotary Engine
Date: 2/26/2009, 6:04 PM
To: AAA Put this in the To box



There is a problem with the coil issue.  When rotating in the start
mode,  the magnet field. will not create enough voltage to  excite the
circuit so  the spark will not jump the gap at compression pressure.
Therefore, a coil needs to be wound with many extra turns in order to
solve the starting problem.   However, the magnet field  when turning at
high speed, will over heat  a coil that is wound for starting
purposes.   The Revmaster coils  are  wound for high speed (3500 rpm)
and  are not capable of producing sufficient voltage in the start
mode.   In order to solve this start and  high speed problem,  the
circuitry incorporates a transformer which boosts the voltage during
starting only.   Once the starter is disengaged, the transformer is out
of the circuit.  For your high speed application of 5000 rpm, depending
on the magnet field, it would require coils that are special wound.  I
suggest that you contact Al D'Alo at A.R.D.  Engineering,
562-863-8362.  He winds our coils for the Revmaster CDI system.

Thanks Joe.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.