I did not mean to send that out to everybody but the
cat is out of the bag so here is what I am going to do.
Those two Revmaster ignition coils put out 300 volts AC. They just
happened to be timed correctly for a two rotor
engine since they were designed for a four cylinder engine.
Two rotor engines fire twice per rev 180 degrees out
of phase.
I intend feeding that 300 volts AC into the primary winding
of 2nd gen Mazda ignition coils minus the igniter parts.
We all have plenty of those lying around.
You unbolt them from the igniter frames and use just the three coils.
One for the upper plugs and one each for the two lower
plugs. You no longer need
the igniter parts with the ballast
resisters that are prone to failure in aircraft use.
The Mazda coils will act as a pulse transformer with
out heating up. Just like a CD ignition coil would work.
Hopefully we will get 20,000 volts or more out of the secondary
to fire the Mazda plugs.
If it works this is just about the simplest and most reliable ignition
system you will find anywhere. No conventional alternator and no battery
required to keep your engine running assuming you are using gravity
feed carburetors. It will work a lot likemagnitoes only better.
You get a free alternator in the bargain.
You adjust the ignition timing by rotating the Revmaster coil assemble.
Paul Lamar
Paul:
This will not work.
1) The two 300 VAC coils generate voltage over the entire 360 degree
rotation of the flywheel, as each magnet segment passes the 300V coil,
not two pulses per revolution.
2) Yes, can use to generate a high voltage, then rectify, charge a cap
and finally trigger an SCR with another sensor to fire the plugs. OMC
used that scheme for years, avoiding the need for a 12 VDC to 300 VDC
inverter..
3) Ignition coil magnetic's are most likely designed to dump energy
stored within their magnetic field, not optimiumized as a pulse
transformer.
4) Finally I suspect the ring gear is the magnet return path between
magnet segments.
JCP
Dang! How did I miss that? Your absolutely right. Thanks for reading my message
and catching that. I saw what I wanted to see.That is why RevMaster have a capacitor
discharge circuit in there. The 300 volts is rectified and charges the capacitor.
The capacitor is then discharged through the primary of the coil by a mag
pickup and transistor.No DC to DC converter necessary. Still works with out a battery.
If we take all but two magnets out it might work but then
the alternator current capacity would be much reduced. Perhaps we can displace
the ignition coils axial by a few inches and use another two rotating magnets also
displaced axial for just the ignition part.Pretty easy to build a stand alone
system along those lines. The 300 volt coils then become the ignition trigger devices.
Worth a try I think. I know where to buy magnets.
True on the inductive ignition coils but they will work as CD pulse transformers
as I have done it several times starting about 40 years ago back in the days
of thyratron and mechanical vibrator based DC to DC converters :) That is about
how old CD ignition systems are :) I think Heathkit had a CD kit I built
and it worked. The mechanical vibrator had a limited life.
Thanks again for reading the message and thinking about it.
Paul Lamar
Paul,
Yes I agree.By charging a cap and retaining use of the timing wheel as
a sensor input youhave the advantage of being able to advance the
timingas rpms increase.
Doug in Japan
Hey Doug your back. I was beginning to think the Maoist got you.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.