I did not mean to send that out to everybody but the
cat is out of the bag so here is what I am going to do.
Those two Revmaster ignition coils put out 300 volts AC. They just
happened to be timed correctly for a two rotor
engine since they were designed for a four cylinder engine.
Two rotor engines fire twice per rev 180 degrees out
of phase.
I intend feeding that 300 volts AC into the primary winding
of 2nd gen Mazda ignition coils minus the igniter parts.
We all have plenty of those lying around.
You unbolt them from the igniter frames and use just the three coils.
One for the upper plugs and one each for the two lower
plugs. You no longer need the igniter parts with the ballast
resisters that are prone to failure in aircraft use.
The Mazda coils will act as a pulse transformer with
out heating up. Just like a CD ignition coil would work.
Hopefully we will get 20,000 volts or more out of the secondary
to fire the Mazda plugs.
If it works this is just about the simplest and most reliable ignition
system you will find anywhere. No conventional alternator and no battery
required to keep your engine running assuming you are using gravity
feed carburetors. It will work a lot like magnitoes only better.
You get a free alternator in the bargain.
You adjust the ignition timing by rotating the Revmaster coil assemble.
Paul Lamar
So Paul, I guess your having or making the accessory case yourself and it's
a special (made to measure).
Are you buying the coils pre wound, I'm guessing you are as you intend to
use the CDI coils.
I had thought you might not be able to by the parts separately - I guess you
can.
George (down under)
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.