Hello Pual,
I agree this is the best ignition system. Are you thinking of
modifying the Harley Alternator or using the Revmaster. I have one
problem with the rev master and that is it would be close to the block
and flywheel that does run hot I was thinking the higher rpm on the
front E shaft is not a problem as the rpm is not a factor. It will
produce more but the reg will look after that. It will cool better on
the front and that is more my concern. What are your thoughts.
on the front we can duct a small amount of air if required.
My question is are you going to modify the Harley unit or use a
Revmaster fly wheel.
Don
The consensus is it will not work with a rotary. I am going to talk
to the coil winder tomorrow and order a couple of custom coils.
Than I will get two magnets and mount them on a wheel intended for the
front of the e-shaft. I'll then test the ignition part of the concept
in my lathe and see if the scheme works. One of the problems may be
not getting enough spark to start the engine. In the mean time the
Harley alternator still looks like the best bet for just the alternator
part. Probably cheaper than the Revmaster system.
The fall back plan is the 300 volt permanent magnet alternator charging a
capacitor for a cheaper capacitor discharge ignition system that
will keep the engine going without a battery. The battery may be
required for starting. Revmaster's price for such a system is $1800.
Pretty steep!
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.