Subject: Connectors for Mazda fuel injectors and pump wanted.
From: Rotary Engine
Date: 2/28/2009, 6:39 PM
To: AAA Put this in the To box


Anybody know where I can get some connectors
for Mazda fuel injectors and high pressure fuel pump?

Well I have the test fuel pluming done.
I don't recommend that Airmotive fuel pressure
regulator because it leaks vacuum around the adjusting screw.
I think a TWM might be a better brand.
When the manifold absolute pressure goes down, because the throttle
is partially closed, so too the fuel pressure. The bottom line is:
it widens the dynamic range of the injectors without staging.

Paul Lamar


This is a timely thread, since I was looking at replacing one electrical
connector for my CAS and one for my fuel injector. I had taken off the
wires from the CAS, and was using molex connectors and a goodly amount
of shrink wrap as stress relief on the wires, and just by a little
manipulation, one of the wires came out of the connector on the CAS. No
confidence inspiring.

Anyone know where I can get the stock (Nippondenso?) Connectors for teh
CAS and fuel injectors? I would feel a lot more confident flying behing
these if I have a choice.

Brian Trubee

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.