Subject: EFI Fuel Design & Test -- WAS: Re: Aeromotive pressure regulator
From: Rotary Engine
Date: 3/2/2009, 11:10 PM
To: AAA Put this in the To box



Paul -

Tracy's approach is the KISS principle at it's best: one high pressure
fuel line & regulated return line for the left tank, and a simple
transfer pump from right to left tank.  (Tracy, jump in here if I got
it wrong.)

I would prefer to control the fuel pressure via Pulse Width Modulation
(PWM) as opposed to using a fuel pressure regulator AND return line(s)
back to the tank(s) AND a fuel selector valve.

I volunteer to build a test rig if we can agree to somewhat
"universal" criteria.

I am ASSUMING the following automotive parts with these
characteristics are available in mass production: (feel free to
reality-check me ... also feel free to identify candidate part
numbers!  :)
1) EFI pump
 a) PWM compatible
 b) integral check valve
 c) in-tank design
2) Electric fuel pressure sensor
3) EFI PWM controller

For a redundant EFI fuel pump system, use separate systems for left &
right tanks, as follows:
1) One EFI pump per tank (left & right)
 a) high pressure fuel output joined via "T" connector
 b) single high pressure fuel line from "T" to fuel rail
2) Two fuel pressure sensors (left & right)
 a) located at fuel rail to eliminate attitude head pressure variance
 b) wired to respective EFI PWM controller via shielded wires
3) Two EFI PWM controllers (left & right)
 a) located near tanks to minimize power EMI noise emission
 b) simple on-off switch controlled
 c) one switch per controller (left & right)
4) PASSIVE fuel transfer
 a) fuel line between tanks, separated by ball valve

Advantages:
- Electric solution, not mechanical (this is debatable)
- Maintains fuel pressure in any attitude (just like a regulator)
- No fuel return lines
- No fuel selector valve
- For redundancy during takeoff, switch left AND right tanks on
- PWM uses less power for EFI pumps
- Failing pump easily identified by increased PWM duty cycle.
- Passive fuel transfer (self leveling) available if/when one EFI PWM
system fails (pressure sensor, PWM controller, EFI pump, wiring, or
power failure)

OK guys, tear it up.  If this sounds like it's a solid approach, I'll
volunteer to:
1) build a test system
2) stress test
3) test failure modes
4) record test parameters (current, pressure, etc.)
5) publish the results and design
This should consist of off-the-shelf components, preferably even
widely-available junkyard parts.  Hopefully this will add to the
"rotary aircraft commons", and leave one less variable that individual
builders to have to overcome.  Ideally, this test rig will consist of
SPECIFIC electrical and mechanical components, circuit schematic, and
fuel plumbing that can be copied for various aircraft.

What I will NOT do is test it with hypergolic fuels.  I'll be using
mogas.  :)

-Vince Orton

Sounds good to me Vince. Take plenty of pictures as you go
along or I'll fly out there and take some myself.
I assume you are near Bracket. I just got my medical and my
bi annual for flying while in Australia so I am not letting
it go to waste. The old 182 will be annualed as well.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.