It is sometimes difficult to mount fuel pumps in AC wings.
Most people don't do it. They mount the pumps on the firewall.
Paul Lamar
Paul,
I'm just starting construction of my fuel tanks for a Zenith CH-640.
I'm opting for a four wing tank system. I'll likely be using a 16b
conversion,
fuel injection based on your designs. With the discussion on-going about
in tank fuel pumps and fuel return lines, I am asking if I need to make
accomodation for anything special. Presently, my tanks have no
provision for
a fuel return or in tank pump. Would it be necessary to design in any
of this stuff?
Thanks, C. Smith
Yes you might think of adding a large removable panel in the root
ribs for internal pumps. The 640 has a nice thick wing for internal
pumps. Looks like the tanks are in the leading edge. If not
practical use two lines from each tank. One for feed according
to the plans and one for return fuel.
Paul Lamar
Correction, I meant 13b engine.
C. Smith--
Might it be better to put a panel on top of the wing with a mounting
cage allowing the in-tank pump to be lowered in from above? Three
advantages:
1) When the pump needs to be changed/serviced/inspected, you don't
need to drain the tank.
2) No liquid fuel in constant contact with a potentially leak-prone
panel seal
3) If there is a leak, it is fuel vapor/fuel to the outside
environemnt rather than fuel into the internal structure/bay of the
aircraft.
The only other thing that might be worth considering is a small
depression (dimple) so that the fuel pump can get the last drop of fuel
out of that tank. We all plan carefully to avoid ever being in a
desperately low fuel state, but it would be very galling to be setting
down in a cornfield when there's still a quart sloshing around in there
that the pump can't access.
Mark Waldron
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.