Subject: EFI Pump Alternatives -- WAS: Re: Aeromotive pressure regulator
From: Rotary Engine
Date: 3/3/2009, 2:42 PM
To: AAA Put this in the To box


 It is sometimes difficult to mount fuel pumps in AC wings.
 Most people don't do it. They mount the pumps on the firewall.

 Paul Lamar

 Paul,

 I'm just starting construction of my fuel tanks for a Zenith CH-640.
 I'm opting for a four wing tank system. I'll likely be using a 16b
 conversion,
 fuel injection based on your designs. With the discussion on-going about
 in tank fuel pumps and fuel return lines, I am asking if I need to make
 accomodation for anything special. Presently, my tanks have no provision
for
 a fuel return or in tank pump. Would it be necessary to design in any of
this
 stuff?

 Thanks, C. Smith

 Yes you might think of adding a large removable panel in the root
 ribs for internal pumps. The 640 has a nice thick wing for internal
 pumps. Looks like the tanks are in the leading edge. If not
 practical use two lines from each tank. One for feed according
 to the plans and one for return fuel.

 Paul Lamar

 Correction, I meant 13b engine.
 C. Smith--


 So the EFI system with a fuel return line would preclude the use of a
 fuel flow meter to  keep track of fuel used and burn, unless someone
 knows of a meter that subtracts the return flow?
 so with a 4 tank system, thats 8 fuel lines, and a tank selector valve
 ganged 4x4? 4 separate fuel pumps, and control wiring?
 No other way to do this? I'm bummin' out.

 C Smith

 Unfortunately that is one of the drawbacks of a fuel return system.

 With the 555 system all injector pulses rates and widths are the
 same so one can build a simple flow meter that consists of diode
 and large capacitor that will sum the pulse width and rate from
 one injector. That sum can be read by a digital voltmeter to give
 you a flow rate. It is calibrated with a pot so it can read
 out GPH to the nearest .01 gallon. Very simple. Computers systems
 do it the same way except they do it in software.
 I might build the diode, capacitor and pot into one of the PC
 boards. You have your choice of read outs. One can probably test
 the scheme on a car EFI system.

 Paul Lamar


Paul, Why not use the Walbro (I believe it was) pumps to transfer fuel from
the tip tanks to the mains? Like the Glastar does. Then you only have 4
lines 1 feed and 1 return from both mains.

Rick in Alaska

By main I think you mean a cowl tank.  Am I correct? Or are talking
four thanks?

I also think you are talking about a Facet low pressure pump.
5 psi. Here is  a picture. The Walbro is a high pressure pump 40 psi.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.