Hi Paul-
Just wanted to share a very earnest conversation I had today.
One of the visitors we got while running the engine was an alleged
former rotary-powered airplane owner. He was terribly interested in
telling us that "Apex seals are completely optional for aviation use.
They're only needed by cars so they can idle; for aviation use they are
not needed."
Wow...
Mark (Rocky Mtn High)
Yes I have heard rumors to that affect. If you can spin it fast
enough to start it will run at high RPM with no apex
seals. The question is: Is that practical? :)
Paul Lamar
Impressive.
What sort of gap losses would such an engine suffer? At what RPM would
that actually be efficient (ie achieves geometric/theoretical
compression and expansion ratio)?
I wonder if an apex seal failure would then not put an aircraft engine
out of commission -- or would the damage done to the rotor or housing
guarantee loss of seal...
-Chris
I don't know the answers. It is just a myth I think.
Paul Lamar
Paul,
we blew up carbon race seals years ago.... leaving very little of the seal
left to do anyting. The engine still ran, but at much reduced power, and
once shut off... forget ever starting it again. We had looked at centrifugal
force retractors to take the spring load off the apex seals at high rpm and
decided it wasn't worth the effort. With the ceramic seals out there now,
for sure not worth the effort.
Larry
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.