Subject: Rotary myths & myth-information
From: Rotary Engine
Date: 3/4/2009, 4:57 PM
To: AAA Put this in the To box


 Hi Paul-

 Just wanted to share a very earnest conversation I had today.

 One of the visitors we got while running the engine was an alleged
 former rotary-powered airplane owner. He was terribly interested in
 telling us that "Apex seals are completely optional for aviation use.
 They're only needed by cars so they can idle; for aviation use they are
 not needed."

 Wow...

 Mark (Rocky Mtn High)


 Yes I have heard rumors to that affect. If you can spin it fast
 enough to start it will run at high RPM with no apex
 seals. The question is: Is that practical? :)

 Paul Lamar

 Impressive.

 What sort of gap losses would such an engine suffer? At what RPM would
 that actually be efficient (ie achieves geometric/theoretical
 compression and expansion ratio)?

 I wonder if an apex seal failure would then not put an aircraft engine
 out of commission -- or would the damage done to the rotor or housing
 guarantee loss of seal...

 -Chris

 I don't know the answers. It is just a myth I think.

 Paul Lamar


 Paul,
 we blew up carbon race seals years ago.... leaving very little of the
seal
 left to do anyting. The engine still ran, but at much reduced power, and
 once shut off... forget ever starting it again. We had looked at
centrifugal
 force retractors to take the spring load off the apex seals at high
rpm and
 decided it wasn't worth the effort. With the ceramic seals out there now,
 for sure not worth the effort.
 Larry

I drill small holes near the apex seal land. Lets more pressure to get
into and behind the apex seal. Greatly reduces the problem of hi RPM
cross over at the minor axis.

Skip Gorman


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.