Subject: REAL cheap and REAL simple ignition system. How it might work.
From: Rotary Engine
Date: 3/10/2009, 10:04 AM
To: AAA Put this in the To box


I suspect if you took two of these old
coils, mounted back to back, 180 degrees out about six inches apart, you
would need nothing else except a powerful rotating permanent magnet. The
primary winding would act as a alternator to generate the ignition
power. I
also suspect If the laminated iron core was replaced with a long
cylindrical
permanent magnet the system would work even better. The magnetic field
would
be twice as strong.
------------------------------------------------------------------------

These coils normally work by the magnetic field created by the primary
coil
collapsing into the iron core passing through the seconday coil
creating the
spike of current in the secondary windings when the current is removed
from
the primay coil. (Larry :)

I am going to try to trick them into thinking the internal magnetic
field has
collapsed by using a rapidly changing external magnetic field. Namely
a rotating
very strong magnet.

Fundamentally this is no different than the permanent magnet sensors
except the magnet
is much much more powerful and a lot more primary current is required
to fire
the plugs so larger wire must be used. Formally magnetic sensors were
made like
this coil and a current had to be generated in the coil by applying an
external voltage which generated the magnetic field. Another analogy
is a permanent
magnet alternator compared to the traditional field winding alternator.

Paul Lamar

Hi Paul,
Are you reinventing the Capacitive Discharge Ignition (CDI)?
Historically (way back),
I thought most ignitions were setup similiar to what you are doing.
The problem back
then was the magnetic field collapsed so slowly that it provided a
whimpy spark of
long duration. A capacitor was introduced to provide a sharply defined
rapid voltage
spike inducing a much higher voltage of shorter duration in the
seconday coil winding
producing a shorter, high energy spark at the plug. Are you thinking
the more powerful
magnets available today will overcome the need for a capacitor or are
you going to
charge a capacitor and use the ABS brake transducer as a signal
trigger to the 555
to fire the capacitor at the appropiate moment? There's been a lot of
subject jumping
lately and I'm starting :) to get lost. Are you exploring TWO
different ignition
concepts simultaneously?  Dave M

No. Most capacitor discharge ignition system jack up the 12 volts to 300
volts, charge a capacitor and discharge it through the primary of an
ignition coil.
They are rather complicated and expensive.

This system has some similarities to a inductive system where a high
current
in the primary is interrupted to affect a rapid change in the magnet
field
which induces a spark from the secondary coil. These system are used
to this
day except the coil dwell time is controlled by a computer and is only
long
enough to build up the magnetic field before it is rapidly interrupted by
a power transistor.

In this system the magnetic field is provided by a large rotating
external
magnet which induces a current in the primary which induces a high
voltage in
the secondary which hopefully will cause a spark. As far as I know it
has never
been done before. Basically the ignition coil is used as a pulse
transformer.
The coil angular positions control the ignition timming.

It is just an idea at this point and will take some R&D to optimize
the system
if it works at all. I may have to rewind the primary with more turns
of smaller
wire.

It will require no battery or alternator if it works.

The ABS brake transducer is not needed here. I am going to use those to
trigger the 555 EFI system.

Sorry about the confusion.

Paul Lamar



Paul, It seem to me that you're missing a magnetic field return path.
Fred O.


I don't think it is entirely necessary.
The ABS or ignition triggers sensors don't have return paths.
The primary is working almost exactly like a sensor.

http://en.wikipedia.org/wiki/Magnetic_field
http://www.coolmagnetman.com/magfield.htm

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.