Subject: P-ports time to climb
From: Rotary Engine
Date: 3/12/2009, 8:09 AM
To: AAA Put this in the To box


BTW speaking of p-ports did you notice the rate of climb for the Power Sport
p-port powered airplanes?

Paul Lamar

Hi Paul,
Beware: that's "INITIAL" rate of clime. Easy to do shooting down a runway
at 90 knots. When you hit the bump at the end you simply measure the rate
for the first 3 feet of altitude. Ski jumper style :)

BTW; I read my ECHO chain saw manual last night and the idle is 3,000 and
WOT is 12,000 RPM. The flywheel is about 4 inches dia and the pickup is
on the OUTSIDE of the flywheel. Outboard motor pickups are on the INSIDE
making them less accessable and more inclined to heat buildup. Chainsaw
parts may be an option.    Dave M

Yes I suppose that is possible if you want to cheat :)
Still I don't think that was the way it was done. 2750 FPM
is only 46 feet per second and the gross weight of 1800 pounds
is only 82800 pound feet per second. Dividing that by 550 is only 150 HP.
Quite possible with a constant speed propeller that is about  85% efficient.
That is 300 to 500 FPM better than most side port rotary and O-360 Lycoming
powered airplanes.

An RV3 (RV4?) powered by a early Power Sport P-port engine, fixed pitch prop
and a bit of NOS holds the unofficial worlds record time to climb to 3000 feet
from a dead stop on the runway in under one minute as I recall. Perhaps Steve
Beckham can expand on this.

Yes that is worth looking into as the parts are a lot cheaper
than an outboard motor. However you don't get the alternator
for free. Thanks for the tip.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.