Symptoms-
If we run the engine with the manifold pressure lines *DISCONNECTED *from
the EC2:
- Engine starts very easily
- The engine runs quite smoothly across a pretty wide rpm band after
tweaking the manual mixture control.
- Reasonably smooth running as low as 1500rpm engine (526rpm prop!)
- Very smooth running 3000 - 4800 RPM.
- Above 4800 rpm we seem to "run out of enrichen" on the manual mixture
control & the engine stops.
- MAP table view on the EM2 real-time shows the EC2 using map location
59
or 91 (MP constant matching atmospheric pressure) depending on high/low
throttle (as expected)
If we run the engine with the manifold pressure lines *CONNECTED *to the
EC2:
- Engine noticeably harder to start
- Engine will not run smoothly at any rpm
- Significant surging pattern -- rpm increases rapidly, followed by
engine stumble to low idle rpm, followed by next surge.
- Engine often stops during the stumble / hard to restart
- MP pressure varies rapidly based on engine rpm
- Significant manual mixture changes can help ease the surges somewhat,
but never enough to get the engine to smooth out enough to let us see if
MAP
values could be tweaked.
Looking at the MAP table with engine off, it seems like all map cells are
at
0 -- as expected. I did not check all 127 cells, only the top cells (say
100 - 127).
Mark (Rocky Mtn High)
----------------------
The surging behavior suggests the engine is running way too lean.
Check the basic pulse width - adjusts with mode 3.
Where are you picking up MAP? Paul's suggestion on damping the
Pulses is a good one. My pickup points are about 8" upstream
From the ports on my 20B. I sense MAP on all three connected together;
And did find that it idled better with some pulse damping. Didn't matter
much above about 1600 rpm.
I put a metal fuel filter, about 2 1/2" dia., in the line, and about a
.040", 1/2" long orifice between the filter and the EC2. It helped to
smooth
things out, although one reason was to smooth out rapid pulsation
I noted in the fuel pressure from the MAP reference pressure regulator
T'd off the same line.
You may want to chat with Tracy on the matter.
Al Gietzen
Thanks for the thought's Al. My pickup point for MAP is about 1.5" from the
pport. Both intakes are T'd together, and then T'd again for the fuel pressure
regulator. Finally, there is a T at the EC2 itself.
Tracy also suggested Mode 3 earlier this evening.
I think what I will start with is a wipe of whatever is in the EC2 right now
& start from Tracy's defaults again. We hit mode 3 pretty hard a few weeks ago to turn
down the larger-than-stock injectors. Then we shipped the EC2 off to Tracy to get
the latest firmware he has for PPorts. Based on Al's comments regarding surging / lean
I wonder if we over did it & the new firmware doesn't like it.
If it still is surging, I'll try sticking in a larger air mass to see what
it does for me.
Mark (Rocky Mtn High)
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.