Subject: pport tuning peculiarity
From: Rotary Engine
Date: 3/17/2009, 9:26 AM
To: AAA Put this in the To box


Hello Paul-

Sent this to Tracy earlier today; thought I would pass it along in case
someone on the list has seen this before...

Had some peculiar behaviors in that latest tuning attempts.Hopefully
you'll have some suggestions.

Background-

- 13b, p-ported, with slide throttle design & "tuned" intakes
- LS1 injectors
- EC2 with latest p-port firmware
- EM2
- 6800 field altitude
- 55F OAT
- Known to be under propped (has a 72x72 160hp 2-bladed prop.Needs a
72x109 230hp 3-bladed prop)

Symptoms-

If we run the engine with the manifold pressure lines *DISCONNECTED*from
the EC2:

- Engine starts very easily
- The engine runs quite smoothly across a pretty wide rpm band after
tweaking the manual mixture control.
- Reasonably smooth running as low as 1500rpm engine (526rpm prop!)
- Very smooth running 3000 - 4800 RPM.
- Above 4800 rpm we seem to "run out of enrichen" on the manualmixture
control & the engine stops.
- MAP table view on the EM2 real-time shows the EC2 using maplocation 59
or 91 (MP constant matching atmospheric pressure) depending onhigh/low
throttle (as expected)


If we run the engine with the manifold pressure lines *CONNECTED *to the
EC2:

- Engine noticeably harder to start
- Engine will not run smoothly at any rpm
- Significant surging pattern -- rpm increases rapidly, followed by
engine stumble to low idle rpm, followed by next surge.
- Engine often stops during the stumble / hard to restart
- MP pressure varies rapidly based on engine rpm
- Significant manual mixture changes can help ease the surgessomewhat,
but never enough to get the engine to smooth out enough to let ussee if
MAP
values could be tweaked.


Looking at the MAP table with engine off, it seems like all map cellsare at
0 -- as expected.I did not check all 127 cells, only the top cells(say
100 - 127).

Mark (Rocky Mtn High)


Hi Mark;

A few questions / comments.
How large is the intake tubing / Pport(1.75" round hole)?

It sounds like the fuel system is not capable of supplying enough fuel.
How many injectors?
What is your fuel pressure?
What is their nominal flow rate and pressure @ 80% duty cycle for these
fuel injectors?
Do you have a fuel pulsation damper in the system?

As people have commented, it sounds like your MAP sensor is being
confused by pressure pulses.
The beer-can accumulator suggestions with separate runner and MAP sensor
lines may help.
If that still doesn't work, you might try adding metal plates and air
filter foam dividers in the can to turn it into an expansion chamber to
try to damp out the pulses.

I have not tuned with Tracy's setup, so excuse my ignorance.Does it
use TPS(alpha), RPM(N), air temp?
Car people have trouble with Pports/ long duration cams which give poor
MAP resolution.
Your MAP will be probably be near atmospheric pressure at idle/ low RPM
and there won't be a huge difference between idle and WOT.
Alpha-N tuning is often used in cases where MAP resolution is small or
to get a smooth idle on engines that have erratic map values.

- Significant surging pattern -- rpm increases rapidly, followed by
engine stumble to low idle rpm, followed by next surge.
- Engine often stops during the stumble / hard to restart
The next time the engine stops this way, check for wet plugs.

Cheers
Cary


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.