Is Richard Sohn any closer to marketing 1 rotor kits?

We'll be in the market for 100 hp single rotor in about a year.

Chris Cosman


There is a 1 rotor project + lots of rotary bits for sale on ebay:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWAX:IT&item=300300476362
Get it before it goes to the crusher.

Cheers
Cary

This is a no reserve auction for all the Mazda rotary parts I've collected over
the years.  There's a complete custom single rotor engine made from new 3rd gen
housings, a 9.7 compression rotor, and custom eccentric shaft and balancing.
It's mounted on a small utility trailer that acts as a test stand.  This was a
running motor that I was planning to use on an aircraft, but plans changed.
There's no throttle body, engine computer, or instruments.

I don't have an extensive inventory of the parts in the bins but here's a rough
estimate:  Six front covers (one is first gen, one is 3rd gen, the others
are 2nd gen).  1 first gen oil/water heat exchanger.  Two or three oil pans,
stock intakes, throttle body(?), lots of fuel rails, stock 2nd gen injectors,
about a dozen spark plugs, first gen ignition coils, a never used electronic
distributor, starter, rotary engine stand head, 3rd gen aluminum AST, 2-3 water
pumps and housings, used 3rd gen front iron housing, used 3rd gen rear iron
housing, Front/rear/intermediate iron housings for 6 port 2nd gen, 2 never
used 9.0 compression rotors, 2 used 9.4 compression rotors, misc parts from
taking a couple engines apart, and a box with other misc small parts.

The starting bid is a penny, and there's no reserve.  The big catch is that
the buyer must pick this all up before the end of March.  I'll be turning in
my hangar, so this stuff has to go.  The hangar is located near Pensacola FL.
None of this will be shipped, or sold separately.  The buyer must take
everything you see in the picture (except the dirty van of course).
If you have any interest in 13B parts, there's plenty here to be worth
your while. Otherwise, it's off to the metal recyclers...

Contact me if you have any questions.  Thanks.

Richard Sohn lives in that area.