Subject: Converting Tracy's system to mass air flow sensor
From: Rotary Engine
Date: 3/19/2009, 5:58 PM
To: AAA Put this in the To box

Don't try this unless you can afford to buy another one.
What you do is unsolder the pressure sensor
and solder in three wires that are going
to your mass airflow sensor.

The mass airflow sensor should have the same three
connections. Signal, power and ground.

The software should work as is.

You can test the mass air flow sensor in your car by bringing out
the signal and ground wires and connect a low cost VOM.
You can then watch what happens as you drive your car
around from idle to full power WOT.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.