Subject: I want to make a rotary engine
From: Rotary Engine
Date: 3/20/2009, 4:50 PM
To: AAA Put this in the To box


Vladimir,
If I understand your inquiry correctly, You are intending to make
complete engine packages for sale.If so - then it depends on
what market you wish to target.Many on this forum are after
high performance 2 or 3 rotor packages.Others want less hp and
weight, so the single rotor information. For the LSA market
100 - 150 hp and wet weight under 160 lbs would be perfect.
The 555 fuel injection being developed here and a no external
source ignition (also being discussed here) are good.

To the mechanical side of a revised (Mazda) design I would investigate
hydroformed e-shaft to reduce weight (if can be done without oiling
problems), lighter rotors that have less combustion heat transfere
than cast iron, aluminum end and center housings, and Pauls favorite
- turbocompounding to get bsfc to .35 or less.

If you have a clean sheet for rotor development please investigate
where the pocket should be for best torque. An inventor I correspond
with believes that a trailing edge pocket would make more power due
to the position of the rotor and e-shaft. He also believes that gearing
the rotor to the e-shaft would harness more torque by using the inertia
of the rotor(s) as well as the "push" from combustion. He also has an
idea to eliminate unburned fuel at the leading edge.
Dan F

Got any drawings on this "gearing the rotor to the e-shaft" Dan?

Paul Lamar


Hi Dan;

This wouldn't be Starapex / Ken, would it?

Here's an interesting DKM engine project from years ago:
http://www.cnczone.com/forums/showthread.php?t=11562

Cheers
Cary


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.