Subject: RB alloy end housings
From: Rotary Engine
Date: 3/20/2009, 4:57 PM
To: AAA Put this in the To box


 Paul, What can you tell me about R B's aluminum side
 housings?
 Any good? Do they work? Know anybody that has them in
 service?
 Do you think they are a good idea?

 Skip

 We have no feedback on them. I have no idea. I guess they
 are too expensive
 for most people. If they work they would be ideal for a one
 rotor
 as that is where engine weight is critical.

 BTW if I were Jim Mederer I would build or buy a LSA and
 install a one rotor p-port. It would be great PR and people
 would flock to
 it simple because a Rotax 912 is now $20,000 US. Jim is a
 pilot and has
 built, flown and owns a Glasair.

 The two rotor weighs about the same as an IO-360 installed
 so there is
 little incentive to reduce engine weight there. One might
 wind up with  an aft CG problem.


Paul Lamar

Couldn't you compensate for the lighter weight by mounting the engine
further forward, and making an appropriate increase in the tubing
used to support the engine. Extra space under cowl allows easier
service, longer nose = less drag?
C. Smith


Yes but.
More work as now you need a new cowl.

Paul Lamar

It's always easier to deal with something that's too light than something
that's too heavy.  Relocating components forward will make up the
difference.  Several airframes are a tiny bit nose heavy with (I)O360's..
If it's too light, add a constant speed prop and then a turbocharger.  An
RV-3b/4/6/7/8 with an aluminum 2 rotor and a constant speed prop which has
an all-up weight around that of one equipped with an O-320 and a wood prop
would be a wonderful performer.


Matt-


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.