The question of Wankel geometry came up recently
in conversation. The leaning angle is the angle the apex seal
makes with the wear surface I think. It is really a complex
function of a lot of variables. As it moves away
from perpendicular the side force on the apex seal is increased.
If the angle is too severe the apex seal could jam in it's slot
or chatter.
In effect this limits the geometry and compression ratio
of the Wankel engine. Here is a chart on the subject from Ansdale.
Also a chart of other possible rotary configurations.
As you can see leaning angles can get out of hand
and contribute to the chatter phenomena.
Here is an interesting idea.
http://adam.standley.googlepages.com/home3
------------------------------------------------------
On a little more thought a DLC or other low friction
coating either on the apex seal itself and/or in the apex
seal slot would extend the life of the apex seal to
way beyond 500,000 miles or 3000 hours in an aircraft engine.
Mazda is already using DLC on the corner seals.
It could perhaps also cut down on the amount of apex seal oil
required reducing the hydro carbon emissions.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.