Subject: RB alloy end housings
From: Rotary Engine
Date: 3/21/2009, 11:09 AM
To: AAA Put this in the To box




Paul, What can you tell me about R B's aluminum side
  housings?
  Any good? Do they work? Know anybody that has them in
  service?
  Do you think they are a good idea?

  Skip

  We have no feedback on them. I have no idea. I guess they
  are too expensive
  for most people. If they work they would be ideal for a
 one
  rotor
  as that is where engine weight is critical.

  BTW if I were Jim Mederer I would build or buy a LSA and
  install a one rotor p-port. It would be great PR and
 people
  would flock to
  it simple because a Rotax 912 is now $20,000 US. Jim is a
  pilot and has
  built, flown and owns a Glasair.

  The two rotor weighs about the same as an IO-360
installed
  so there is
  little incentive to reduce engine weight there. One might
  wind up with  an aft CG problem.


 Paul Lamar

 Couldn't you compensate for the lighter weight by
 mounting the engine
 further forward, and making an appropriate increase in the
 tubing
 used to support the engine. Extra space under cowl allows
 easier
 service, longer nose = less drag?
 C. Smith


 Yes but.
 More work as now you need a new cowl.

 Paul Lamar


Hmmm. So we are using an experimental engine conversion in
an experimental
plane, using mounts mostly designed for one off
configurations, with cooling,
fuel, and ignitions systems of our own design, and we
suddenly deem it
unusual, or too much trouble to design a cowl, that
probably ends up
completely different from an air-cool opposed something,
because a
new cowl is more work? HUH?!?
I'd like to know who, among the current successful
rotary conversion
flyers is using a stock cowl, or that had to modify the
stock  cowl so much that a clean sheet would have been
comparatively  cost effective?
C. Smith

Most are using stock cowls. All those airplanes featured
on the ACRE NL web site. http://www.rotaryeng.net are stock
cowls  except Mark Suspinski's.
As I said it adds to the work required for a 50 pound
increase in payload
and a huge increase in the cost of the engine.

Paul Lamar


If one was making their own cowl anyway, it is no more work.
The effort of getting a liquid cooling system to function in
a cowl designed for an aircooled opposed something sounds
like more work to me. I think it's all subjective.
Your results may vary.
C. Smith

Don't underestimate the time and money to make a custom cowl.
In Mark's case it added nearly a year and he farmed it out I think.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.