Subject: I want to build a rotary engine
From: Rotary Engine
Date: 3/23/2009, 11:02 PM
To: AAA Put this in the To box


Hi Vladimir,

This link http://www.starapex.com/ last drawing has some potential for a
compound/steam engine.

Check this link  http://issuu.com/infohuntr/docs/popsci200706/68

Marc Joseph

The first one is related to the Wankel engine and the principle
has been known for more than 60 years. See the attached chart.
It is the one on the lower right. If it worked Felix would have
chosen it :)

The second one injects water into the engine every now and
then. The water cools the engine and is converted to steam
which expands and pushes the piston down. Sort of a marriage between
the steam engine and the gasoline engine. The water is a total
loss system.  Then some gasoline must be burned to heat the
engine up again. The trouble is the water
deposits will foul the engine so distilled water must be used.
Distilled water is not energy free. It takes heat to distilled water
unless it is done with sun light but that is not free either.
Somebody must spend money to do it, ship and distribute the distilled
water. Right now distilled water cost more than gasoline. You will
still have a rust problem in most engines. Water will also get into
the crankcase oil causing catastrophic structural failure. That might
be solved with a "dry" (wet? :)) sump system and a water and oil separator.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.