Here are a few charts from Heinz Heislers book Advanced Engine
Tech and others. The first chart shows that; as the fuel air ratio gets
real lean and the pressure lowers in the combustion chamber
at high altitude the voltage required to fire the plugs goes up.
Klaus has exploited this situation to lean his engine out
at high altitude and improve the BSFC to remarkable levels
by increasing the spark voltage. He has achieved as much as
100 MPG at 130 MPH and 60 MPG at more reasonable cruising speeds.
This is a piston engine where the spark plugs are at one end
of the fire and the piston is at the other end.
In our case we have a moving combustion chamber where the fire
travels along side the spark plugs for quite some time. IMHO We want
the spark plugs to continue to fire for as long as the unburned
and burning mixture is still present moving past the plugs. That takes
8.3 ms at six thousand RPM cruise RPM. See chart 2.
A capacitor discharge ignition system is very good at firing
spark plugs fouled with 100 LL but it only fires for .2 ms. Even
an inductive system (Chevy LS1 coil) or stock Mazda ignition
only fires for about .8 ms.
IMHO NO WHERE LONG ENOUGH FOR WHAT WE NEED!
IMHO we need an ignition system to fire for 8.3 ms or 300 degrees.
TEN times as long. MSD makes a multiple spark capacitor
discharge ignition system widely used by Mazda rotary
engine racers but it only works up to 3000 RPM. After that it
is "one strong spark" says MSD. Not enough in IMHO. This is why
I am doing a m.s.d. ignition system with several pre-charged
capacitors fired in rapid sequence by a cheap single chip computer.
I hope this is a break through in improving the BSFC of
the rotary engine. I think it is worth a try.
Patent applied for :)
Paul Lamar
Hi Paul,
Definition of "several"?
8.3 ms / .2 ms (from 3rd chart) = 41 capacitors required??? Times 4 plugs???
Are you intending to sequentially fire 82 capacitors per rotor?
At 7000 RPM can that many capacitors be recharged fast enough to be
ready for the next event?
Dave M
Good thinking Dave. Thanks.
No. Maybe only five or six times per rotor e-shaft rev in 270 degrees or
once every 20 to 45 degrees E-shaft or so. The time time to charge the
spark capacitors is a function of the output resistance of the 300 volt
supply. All will be recharged on a continuous basis. Since I plan on
using the outboard motor 300 volt alternator to charge the capacitors
through diodes I hope it can generate the required current with the
stock two alternator coils but maybe I need more alternator
coils or a compromise on the number times fired.
BTW This does away with the 12 volt to 300 volt expensive converter
used in most CD systems.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.