Here are a few charts from Heinz Heislers book Advanced Engine
Tech and others. The first chart shows that; as the fuel air ratio gets
real lean and the pressure lowers in the combustion chamber
at high altitude the voltage required to fire the plugs goes up.
Klaus has exploited this situation to lean his engine out
at high altitude and improve the BSFC to remarkable levels
by increasing the spark voltage. He has achieved as much as
100 MPG at 130 MPH and 60 MPG at more reasonable cruising speeds.
This is a piston engine where the spark plugs are at one end
of the fire and the piston is at the other end.

In our case we have a moving combustion chamber where the fire
travels along side the spark plugs for quite some time. IMHO We want
the spark plugs to continue to fire for as long as the unburned
and burning mixture is still present moving past the plugs. That takes
8.3 ms at six thousand RPM cruise RPM. See chart 2.

A capacitor discharge ignition system is very good at firing
spark plugs fouled with 100 LL but it only fires for .2 ms. Even
an inductive system (Chevy LS1 coil) or stock Mazda ignition
only fires for about .8 ms.

IMHO NO WHERE LONG ENOUGH FOR WHAT WE NEED!

IMHO we need an ignition system to fire for 8.3 ms or 300 degrees.

TEN times as long. MSD makes a multiple spark capacitor
discharge ignition system widely used by Mazda rotary
engine racers but it only works up to 3000 RPM. After that it
is "one strong spark" says MSD. Not enough in IMHO. This is why
I am doing a m.s.d. ignition system with several pre-charged
capacitors fired in rapid sequence by a cheap single chip computer.
I hope this is a break through in improving the BSFC of
the rotary engine. I think it is worth a try.

Patent applied for :)

--------------------------------------------------

This is the range of rotor positions I intend repeatedly firing the spark
plug. Mostly the leading plug (lower plug) as one does not want to risk
igniting the mixture in the following chamber.

Paul Lamar

Good going Paul. We need the long duration. Will be very interesting.
Sure wish we access to the Mazda factory development notes and a supply of
the three sparkplug rotor housings the Mazda factory built for the R26B
LeMan's engines to improve efficiency.

Steve Beckham

Steve,
Heck I would just like to be able to buy factor P-port housings for a reasonable price!
2 plug or 3 I don't care.
Paul,
I think the long spacing idea is a good one. The only concern that I have is actual
spark duration. Modern coils and CD ignition may improve things there. At Kawasaki
in the 2 stroke era there were many single-spark CDIs. We found that the super short
spark duration was a problem when lighting lean mixtures. Kawasaki had tried surface
gap spark plugs, which had no side wire. The business end of the plug looked like a little
target with the center electrode as the bullseye,a ceramic stripe and them the case
of the plug outside that. the surface gap plugs didn't work well because they carbon
tracked easily and then there was a conductor for the spark to jump through. Later
the choice was a standard plug with an incredibly large gap, around .100 inches!
Surprisingly this worked well because there was plenty of voltage to fire the gap, and
with the long (length) spark they were more likely to actually hit some of the mixture
molecules! The large gap standard plugs with single shot CDI lasted to the end of the
2-cycle era. If the duration of the spark can be improved you will have better results
when firing the lean mixtures we want to run to improve BSFC on the rotary.
Bill Jepson