Subject: I might not have to reinvent the wheel after all. Yes I do.
From: Rotary Engine
Date: 3/27/2009, 12:47 PM
To: AAA Put this in the To box


 Here is a company (AEM) pretty much making
 what I had in mind (I think). Two capacitors.

 http://www.aempower.com/ViewCategory.aspx?CategoryID=78

 The only drawback is it need a conventional battery and alternator.

 Thanks Larry.

--------------------------------------------------

I called AEM and it does not fire more than once past 3000 RPM
according to the electronic tech guy. He kept saying there was
not enough time but he was incorrect about that in a rotary.
I don't think they designed it for a rotary where the rotor is
moving one third as fast as the shaft.

Back to square one. IMHO AEM like MSD do not understand the rotary.
The expansion cycle in a piston engine takes place much faster
than in a rotary. 90 degrees instead of 270 degrees. It also
happens at one end of the combustion chamber while the combustion
chamber in a rotary moves past the spark plugs. I also think Mazda
is missing a bet on this. We have got to think outside the
piston engine ignition box.

IMHO We want
the spark plugs to continue to fire for as long as the unburned
and burning mixture is still present moving past the plugs. That takes
8.3 ms at six thousand RPM cruise RPM. See chart 2. Much much more
at lower RPM where Mazda is most concerned with emissions
and fuel burn (BSFC).

A capacitor discharge ignition system is very good at firing
spark plugs fouled with 100 LL but it only fires for .2 ms. Even
an inductive system (Chevy LS1 coil) or stock Mazda ignition
only fires for about .8 ms.

 IMHO NO WHERE LONG ENOUGH FOR WHAT THE ROTARY NEEDS!

 IMHO the rotary needs an ignition system to fire for 8.3 ms or 300 degrees.

This is why I am doing a m.s.d. ignition system with several pre-charged
capacitors fired in rapid sequence by a cheap single chip computer.
It will be designed to work up to 7500 RPM in a rotary.

Initial proposed ignition software strategy is: Start a 16 bit counter with
input from an oscillator (say 10,000 hertz or cycles per second) when the
e-shaft trigger pulses. Stop the counter when it pulses again.
Read the number in the counter and restart the counter.

That number will be inversely proportional to the RPM.
Big number low RPM. Small number high RPM. Divide the number
by 360 and that result will be the number of counts per degree
of e-shaft rotation. Use that count number to fire the plugs
at 20 degrees BTDC and once every 10 degrees there after for
five or six times. Thats it.

This is the range of rotor positions I intend repeatedly firing the spark
plug. Mostly the leading plug (lower plug) as one does not want to risk
igniting the mixture in the following chamber.

I hope this is a break through in improving the BSFC of
the rotary engine. I think it is worth a try.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.