Joe, here are the three possible locations for the drain. Of course, it
can be put anywhere you like. Photo "A" is on the bottom as close to
the deep end as possible. Up to now, this has been where I have been
installing the drains. Photo "B" The drain is on the back face. The
last three photos show the drain on the front face just below the
S-beam. This is the ideal position if you want to use a pump. Feed
the suction hose to the rear of the pan. Couldn't be neater--- if a
pump can be found with a hose that will fit through the drain hole.
BTW, I just assembled the pan/sbeam with a couple of loose bolts for
these photos. Properly installed every thing will line up perfectly. :)
Jerry
-
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.