Subject: Jet carb and Holley 2 barrel
From: Rotary Engine
Date: 3/31/2009, 4:44 PM
To: AAA Put this in the To box

I notice Summit as a 500 CFM two barrel called a Jet for $285
in the 2007 cat.
Holley also has a 500 CFM 2 barrel for $269.

Now if we can just figure out how to lean em.
The Holley might be easy as it has a screw in adjustable float
valve.
http://www.holley.com/types/Street%20Performance%20-%20Traditional.asp

Paul Lamar


Paul,
I have run the holley 2 barrel and 4 barrel carbs on rotary's many times.
Power valve must be removed and blocked to work on a p port or even a bridge
port engine. The strong pulses drive the power valve crazy.
To make any power with the 500 cfm 2 barrel, it will require an open plenum
beneath the carb, at the end of the long tubes. A 600 cfm 4 barrel works
well on a ported side port engine, and a 465 cfm works on a non ported side
port engine, both with separtate runners for each port.
Weber at one time made metering plates for the holleys that worked far
better than the stock holley parts. It had jets mounted on the ends of
vertical imulsion tubes like a weber. If you had those and put a tapered
needle down the center of the jet, that would give you the best leaning
control on the jet. That works better for leaning than lowering the float
level. If you do it by lowering the float level, and need to go to climb
power in a hurry, you could be in trouble as the float bowl level will not
come up as fast as pulling a needle out of the jet.
Larry

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.