Subject: Jet carb and Holley 2 barrel
From: Rotary Engine
Date: 3/31/2009, 5:19 PM
To: AAA Put this in the To box


 I notice Summit as a 500 CFM two barrel called a Jet for $285
 in the 2007 cat.
 Holley also has a 500 CFM 2 barrel for $269.

 Now if we can just figure out how to lean em.
 The Holley might be easy as it has a screw in adjustable float
 valve.
 http://www.holley.com/types/Street%20Performance%20-%20Traditional.asp

 Paul Lamar


I have a device that allows leaning of the 2 bbl Holley.  It replaces
the metering body that goes between the main venturi body and the float
bowl
on a 2 bbl carb.  I'm not sure exactly how it works though.  Best I can
recall, it has an electronic control with a knob that you turn.  I'll look
at it tonight and take some pics.

Mark S. (Cent. Texas)

Paul,
here is the holley brand external adjustment. Just replace the needle with a
new one that has a bellcrank attached. cable operate.
http://www.dougherbert.com/adjustajetkit-p-19502.html?cPath=6_49_51
simple as apple pie for those who want to run a holley.
Larry

I think an RX8 engine p-port with a 500 CFM Holley 2 barrel would
be a good low cost solution. It would idle as well as a side intake port 13B
and have almost as much power as a 13B p-port. No need for butterflies
in the rotor housings or slide throttle mounted next to
the rotor housings. The runners could come forward to the
down draft carb mounted up along side the bell housing.
You would need carb heat of course.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.