Bob, I'm very curious to what size the turbine housing is? 1.0 or
better?
Very nice job Bob.
thanks Skip
--
Skip,
The turbo is a Turbonetics T04B, Model 60-1, with a "Big Shaft" (for
less stress on the bearings). The housing has a divided tang with "P"
trim. AR is 1.15. Wastegate is an externally mounted Deltagate Mark
II, which can be set to provide between 3-5 lbs of boost. I also have
a
panel mounted, manually controlled, regulator that can increase the
boost up to an additional 10 lbs. See
http://www.turbocharged.com/main.htm Click on the catalog link and
then
on the Turbocharger link. The compressor map shows that this turbo
will
spin at 70-80 thousand rpm with 5-10 lbs of boost for the airflow
produced by the Mazda 13B rotary.
Bob
What airflow number are you using Bob.
Paul Lamar
Thanks Bob for the info.We used many 60-1 set ups on the third gen RX7.
It is very efficient at 15 psi. A/R of 1.15 is good for passing alot of
exhaust and slow down the "spool up".
I'm impressed Bob, good job.
Is your engine "P"ported?
Skip
No, it is a stock 1987 13B turbo engine, with stock 8.5:1
low-compression rotors (to avoid detonation). I chose the turbo engine,
among other reasons, to use the turbo as a muffler and avoid having to
find a muffler strong enough to handle the hot exhaust. It seems to be
pretty effective as a muffler, as well as generating extra power.
Bob
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.