Subject: used rotor inspection
From: Rotary Engine
Date: 4/7/2009, 9:00 AM
To: AAA Put this in the To box


recently  purchased a pair of NA rotors to replace the lower
compression
turbo rotors. What is one to look for in inspecting them
for
serviceability.
I noticed in the web around the center bearing  there are
some markings in
the casting that could be cracks or  artifacts from the
manufacturing
process.
I'll  try to take some close up photos to post later.
Any help is  appreciated.
C. Smith



I'll buy the  lower compressiom rotors.

Skip



Would you be interested in the turbo and associated
hardware as  well?
C. Smith


Yeah I'd interested once I see what  the year actually
is.

Skip
--
Paul had dated the engine to  89-92 range, the fuel
injectors were red,
someone mentioned that was  another method to date it.
I'm too inexperienced
to fine tune it further,  and no one else has offered any
hints to narrow it
down.
I'll be going  out to the hangar later today, to
proceed with further tear
down. If there  is anything I can photograph for you, let
me know.

Getting back to the  original topic of the post, since no
one is addressing
it, and I have not  heard any mention of cracking in rotors
on this list,
I'll assume that I'm  looking at artifacts of the
casting cores inside the
rotor web that  supports the center bearing. If anyone has
any other
information, I'd sure  appreciate to hear it. It's
a very difficult spot to
photograph, and very  low contrast surface.
C. Smith

The internal structures will show evidence of sand casting.
No further
finish is used. I have never seen a stock rotor with a
crack in it. I have seen
many lightened racing rotors with cracks. Not just because
they had been
lightened, but because with light rotors you can shift
above 10,000 RPM without
hurting the bearings.

If the Apex seal grooves are good, and there is no damage
like bent corners
or dents that close up a seal groove, then the rotor is
probably just fine.
The  rotors are very strong and not highly stressed.

Lynn E. Hanover

THANKS! Lynn, that was very helpful.
C. Smith

You can always close the grooves with a hammer and regrind them :)

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.