Subject: Low cost first step in turbo compound.
From: Rotary Engine
Date: 4/8/2009, 11:31 AM
To: AAA Put this in the To box



This wireless torque sensor technology could be applied to a short
small diameter shaft extending out of the intake side of a turbo charger.
The end of the shaft would have a small adjustable pitch propeller capable
of 100,000 RPM to act as an adjustable load. The torque sensor is wireless
so nothing else is necessary. No need to make a reduction gear box yet.

This first step is to demonstrate the amount of excess HP
from the turbo charger turbine. Any automotive turbo charger
will work and it is then possible to evaluate different turbine
configurations for aircraft use optimization purposes.

If the torque on the shaft is two foot pounds at 100,000 RPM the HP is
2 X 100,000/5252 or 38 HP. Feeding the turbine power back into the output
shaft for a 200 HP base engine the power would jump to 238 HP with the
same fuel burn. The rotary engine BSFC would then be .46 times
200/238 or .386 which is a very significant reduction in fuel burn
only possible in true diesel engines.

Paul Lamar


Why the need for a torque sensor? I read the pdf and while it gives
plenty of specs, it doesn't really disclose the purpose. Speaking of
reduction gear box, if I recall correctly, you had begun to build
one on AREN didn't you? How was/is that comming along?

Vlad

It is almost finished but I ran out of money to test it.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.