Subject: Video of First Flight - Mustang II w/ 13B Rotary Engine
From: Rotary Engine
Date: 4/8/2009, 2:23 AM
To: AAA Put this in the To box



Bob, I'm very curious to what size the turbine housing is? 1.0 or
better?


Very nice job Bob.
 thanks Skip
--
Skip,
 The turbo is a Turbonetics T04B, Model 60-1, with a "Big Shaft" (for
less stress on the bearings). The housing has a divided tang with "P"
trim. AR is 1.15. Wastegate is an externally mounted Deltagate Mark
II, which can be set to provide between 3-5 lbs of boost. I also have
 a
panel mounted, manually controlled, regulator that can increase the
boost up to an additional 10 lbs. See
http://www.turbocharged.com/main.htm Click on the catalog link and
 then
on the Turbocharger link. The compressor map shows that this turbo
 will
spin at 70-80 thousand rpm with 5-10 lbs of boost for the airflow
produced by the Mazda 13B rotary.
 Bob
 What airflow number are you using Bob.
 Paul Lamar

 Thanks Bob for the info.We used many 60-1 set ups on the third gen RX7.
 It is very efficient at 15 psi. A/R of 1.15 is good for passing alot of
 exhaust and slow down  the "spool up".

 I'm impressed Bob, good job.

 Is your engine "P"ported?

 Skip

 No, it is a stock 1987 13B turbo engine, with stock 8.5:1
 low-compression rotors (to avoid detonation).  I chose the turbo engine,
 among other reasons, to use the turbo as a muffler and avoid having to
 find a muffler strong enough to handle the hot exhaust.  It seems to be
 pretty effective as a muffler, as well as generating extra power.

 Bob


Bob,
what compressor wheel and housing is on your turbo?
Thanks,
Larry

Paul,

This turbine might be just the ticket for the turbo compound test.

Doug in Japan.


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.