Subject: Mass produced 13B PSRU
From: Rotary Engine
Date: 4/12/2009, 8:58 PM
To: AAA Put this in the To box

Greg and Paul,

Many years ago I was reading about race car suspension uprights. The author
suggested a double wall steel desigh as being as light (or almost) and stiffer
than an aluminum upright..
With the hard work done developing the Iron Eagle furnace brazed engine, would
a furnace brazed 4130 stamped steel and some machined parts, like bearing race
lands, be weight and cost competative with aluminum?  I would suggest three
designs if going after the most popular markets -  ie LSA @ up to 150hp,
experimental @ up to 400 hp, and experimental @ up to 1000 hp.  Gear ratio
varations for all and prop flange variations for the experimental classes. All
of which makes for a lot of designing.  :D


Dan F


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.