Subject: Better p-port outer seal
From: Rotary Engine
Date: 4/29/2009, 3:34 PM
To: AAA Put this in the To box

The P-port is the best way to go for rotary aircraft engines
as it is an easy and sure 250 HP at 7500 RPM take off with a simple
to make intake manifold. Low cost Holley 2 brl carb or expensive fuel
injection can be used.

I am trying to come up with a simple way of using
an O-ring for the outer p-port seal. This would be replaceable
and less prone to error than bonding the tube in place with JB-weld
or epoxy. It would also expand and contract as the relative temperature
of the Mazda rotor housing and the SS intake tube changes.

We need a flat surface perpendicular to the tube to mount the O-ring.

The goal was to use the same mill set up used for boring
the 2 inch hole for the SS tube welded to the steel rotor housing liner.
A simple mill and a lathe are all that is required to do this.

This is what I have come up with so far. A 2.5 inch diameter aluminum
cylinder will be pre machined to slip into a hole in the outer water
jacket wall. It will then be tig welded in before the final two inch
hole is bored in the rotor housing.

A flat collar will slip over the tube and be held in place by small machine
screws installed in drilled and taped holes in the rotor housing.
This collar will compress the O-ring and hold it in place
around the SS tube.

I am open to other ideas. I would like to avoid the high cost of an NC
mill and complications to make 3D surfaces to hold the O-ring.

We are currently adding Al material to a junk rotor housing using tig to see if
it warps the side sealing area. This might be the lowest cost solution
if it does not warp the housing. A lot of heat is needed to do this
however.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.